The ruler settings in the Project / Project Settings pane will apply to all new documents in this project.The ruler settings in the Scrivener / Preferences pane will apply to all new documents in all projects.The ruler you set will have an effect according to which one you use. However, to delete it altogether, drag it up or down until it disappears.Īs I explained in an earlier post, there are levels of formatting. Dragging it beyond the right-hand indent also makes it redundant. Deleting a setting: dragging a tab stop so that it coincides with another effectively deletes it.To change that, right click on it and select the tab type you require: centre, right or decimal. You can add a new tab stop by clicking at the required position on the ruler.The measurement is revealed while you drag so you can be quite precise in your placement. You can move any of the current settings by clicking on them and dragging them along to the new position.How do you change the settings on the ruler itself? Change the settings on the ruler itself, either within the document or within the Formatting tab of the Compile function.From within a document, select Format / Paragraph / Tabs and Indents … and complete the Paragraph Indents form with your required values.Ruler settingsĬhanging the settings for indentation or tabs is straightforward. If some of your material requires a lot of layout control, you might set up the indents and tabs within the Editing pane (just for a single document) and then use As Is for your section type for that document. The left-triangle at 5.5 is a right-align tab stop.The circle with a dot in it at 3 is a decimal tab stop.The diamond at 2.5 is a centre tab stop.The right-triangle at 1 and at 1.5 are left-align tab stops.If you want hanging indents, this rectangle needs to be left of the left indent marker. The rectangle at 0.5 represents the indentation for the first line of each paragraph.This is the amount by which the text is offset from the left and right margin respectively. The down-triangles at 0 and 6 indicate the left and right indents.They reveal the current settings for indentation and tab stops. The symbols on all rulers have the same meanings. Within Compile, in the Section layout tab, for each of the section layouts.At the top of the Editing pane (if it’s not hidden!).In the Project / Project Settings pane, in the Formatting tab.In the Scrivener / Preferences / Editing pane, in the Formatting tab.
0 kommentar(er)
